Allied Telesis AT-S63 - Manual (Page 444)

Chapter 28: TACACS+ and RADIUS Protocols
444 Section VII: Management Security
Displaying the RADIUS Settings
To display the RADIUS settings on the switch, perform the following
procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 177 on page 440.
2. Select the Mgmt. Protocols option.
The Mgmt. Protocols tab is displayed with the Server-based
Authentication tab selected by default, as shown in Figure 177 on
page 440.
The upper part of the page shows if server-based authentication is
enabled or disabled and the authentication method. The lower part of
the page allows you to view either the settings for the current
authentication method.
3. In the lower portion of the page, click RADIUS Settings.
4. Click View.
The RADIUS Client Configuration page is shown in Figure 178.
Figure 180. RADIUS Client Configuration Page
The upper portion of the page displays the following information: