Configuring radius – Allied Telesis AT-S63 User Manual
Page 442
Chapter 28: TACACS+ and RADIUS Protocols
442
Section VII: Management Security
Configuring RADIUS
To configure RADIUS, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38
2. Select the Server-based Authentication tab.
The Server-based Authentication tab is shown in Figure 175 on page
436.
3. In lower section of the Server-based Authentication tab, click RADIUS
Configuration and click Configure.
The RADIUS Client Configuration page is shown in Figure 176.
Figure 179. RADIUS Client Configuration Page
4. Configure the following parameters as necessary.
Global Encryption Key
If all of the RADIUS servers have the same encryption secret, you can
enter the key here. If the servers have different keys, you must specify
each key when you specify a server’s IP address. The maximum key
length is 39 characters.