Allied Telesis AT-S63 - Manual (Page 336)

Chapter 20: Multiple Spanning Tree Protocol
336 Section IV: Spanning Tree Protocols
Displaying the MSTP Configuration
To display the MSTP configuration, perform the following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 42.
2. From the Monitoring menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab displayed by
default, as shown in Figure 27 on page 98.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 123 on page 302.
This tab displays information on whether spanning tree is enable or
disabled and which protocol version, STP, RSTP, or MSTP is active.
4. Click View.