Allied Telesis AT-S63 User Manual
Page 185
AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations
185
Note
The Configure Egress Weights section in the tab is explained in the
next procedure, “Configuring Egress Scheduling” on page 186.
The default values are listed in Table 4.
4. In the Configure CoS Queues to Egress Queues section of the tab,
click the list for a CoS priority whose queue assignment you want to
change and select the new queue.
For example, to direct all ingress tagged packets with a CoS priority of
5 to egress queue Q3, you would use the list in CoS 5 to PQ and
select Q3 - QoS PriorityQ 3.
5. If desired, repeat Step 4 to change the egress queue assignment of
other CoS priorities.
6. Click Apply.
7. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Table 4. Default Mappings of IEEE 802.1p Priority Levels to Egress Priority
Queues
IEEE 802.1p Priority
Level
Egress Port Priority
Queue
0
Q1
1
Q0
2
Q2
3
Q3
4
Q4
5
Q5
6
Q6
7
Q7