Allied Telesis AT-S63 - Manual (Page 173)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 173
4. Click Create.
The Create ACLs page is displayed, as shown in Figure 55.
Figure 55. Create ACLs Page
5. Configure the following parameters:
ID
Use this field to enter an ID number for the ACL. Every ACL on the
switch must have a unique ID number. The range is 0 to 255.
Classifier List
Use this list to select the classifier you want to assign to this ACL. You
can assign more than one classifier to an ACL. To select multiple
classifiers, hold down the Ctrl key while making your selections. To
view the classifiers on a switch, refer to “Displaying the Classifiers” on
page 169. An ACL must have at least one classifier.
Action
Use this menu to specify the action of the ACL. Deny, which is the
default, discards ingress packets that match the defined traffic flow of
the classifier. Permit accepts the packets. The default is Deny.
Description
Use this field to enter a description for the ACL. A description can be
up to 15 alphanumeric characters, including spaces. A description is
optional.
Port List
Use this list to specify the port where you want to assign the ACL. You
can assign an ACL to more than one port. To select multiple ports, hold
down the Ctrl key while making your selections. You do not have to
assign an ACL to a port when you initially create it. However, an ACL
that is not assigned to any port is considered inactive.