Allied Telesis AT-S63 - Manual (Page 440)

Chapter 28: TACACS+ and RADIUS Protocols
440 Section VII: Management Security
Displaying the TACACS+ Settings
To display the TACACS+ settings on the switch, perform the following
procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 42.
2. Select the Mgmt. Protocols option.
The Mgmt. Protocols tab is displayed with the Server-based
Authentication tab selected by default, as shown in Figure 177.
Figure 177. Server-Based Authentication Tab (Monitoring)
The upper part of the page shows if server-based authentication is
enabled or disabled and the authentication method. The lower part of
the page allows you to view either the settings for the current
authentication method.
3. In the lower portion of the tab, click TACACS+ Settings.
4. Click View.