Metrohm 915 KF Ti-Touch - Manual (Page 111)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
11 Device manager
915 KF Ti-Touch
￭￭￭￭￭￭￭￭ 97
[Special beakers]
Define rack positions as special beakers (see "Editing special beakers",
page 98).
Lift positions Tower 1/2
Sample rack list: Rack
▶ Edit ▶ Lift pos. tower 1 / Lift pos. tower 2
You can define rack-specific lift positions in the dialog Edit rack data /
Lift positions tower 1/2. These then apply for all rack positions except
those that have been defined as special beakers.
These positions can be moved to directly under manual control and with
the LIFT command. Only lift positions within the maximum stroke path can
be entered. This is defined in the device properties of the tower.
NOTE
These lift positions can also be assigned directly in manual control after
moving to the desired lift height (see Chapter 27.6.1, page 251).
Work position
At this lift position the electrodes, stirrer and buret tips are optimally posi-
tioned for work.
Input range 0 - 'maximum stroke path' mm
A lift position of 0 mm corresponds to the "home
position", i.e. the lift is located at the upper stop
position. The maximum stroke path is defined in the
properties of the tower (see "Maximum stroke
path", page 88).
Rinse position
Lift position used for rinsing.