Metrohm 915 KF Ti-Touch - Manual (Page 265)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
27 Manual control
915 KF Ti-Touch
￭￭￭￭￭￭￭￭ 251
[Rack position]
Move the rack to any sample position or to defined positions which are
defined as special beakers (see Chapter 27.6.2, page 253).
[External position]
This button is only enabled when a Swing Head is mounted to the Sample
Processor.
Swing the robotic arm to an external position outside the sample rack and
assign the swing angle and the lift position (see Chapter 27.6.3, page
254).
27.6.1 Moving the lift
Manual control: Sample Processor ▶ Lift
In the dialog Sample Processor / Lift, you can move the lift to any lift
position. You can also define frequently used positions (work position,
rinse position, etc.) as specific lift positions and then to move to them with
ease (see "Assigning lift positions", page 252). This definition is possible
in this dialog for the attached rack, and in the device manager for all of
the racks in the list.
Current lift pos.
Current lift position.
Move to lift pos.
Selecting a predefined lift position or enter any lift position.