Metrohm 915 KF Ti-Touch - Manual (Page 61)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
8 Titrants
915 KF Ti-Touch
￭￭￭￭￭￭￭￭ 47
￭ Data on exchange/dosing unit:
– Parameters for the function PREP
– Length and diameter of the tubings
– Port assignment of the dosing unit
– Cylinder volume
– Serial number
– etc.
￭ etc.
NOTE
If data is read out from the data chip, then a check is made whether
the titrant list already contains a titrant of the same type with the iden-
tical serial number. If this is the case, then the older data set will
always be overwritten by the new data set, no matter whether the
data set in the titrant list or the data set on the data chip is the most
recent one.
[New]
Add a new titrant to the list (see Chapter 8.1, page 47).
[Delete]
Delete the selected titrant from the list.
[Edit]
Edit the data of the selected titrant (see Chapter 8.2, page 48).
8.1 Adding a new titrant
Before you can use a titrant, you must add it to the titrant list. To do this,
use the button [New].
￭ Exchange unit/dosing unit with data chip:
The exchange unit or dosing unit must be attached. All dosing devices
on which non-configured exchange or dosing units have been detec-
ted are included in a selection list. Tapping on the button [Edit] opens
the properties dialog, see following chapter.
￭ Exchange unit without data chip:
The properties dialog is opened after the dosing unit type has been
selected, see following chapter.