Metrohm 915 KF Ti-Touch - Manual (Page 23)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Overview of the instrument
915 KF Ti-Touch
￭￭￭￭￭￭￭￭ 9
11 Bottle holder
With holding clips, for reagent bottle.
12 Support rod (lower part)
For mounting the support rod (upper part).
13 Titration stand
With built-in magnetic stirrer and membrane
pump for placement of the titration cell.
3.2 Rear of the instrument
8 9
1 2 3 4 5 6 7
10
Figure 2 Rear 915 KF Ti-Touch
1 USB connector (type A)
For connecting a printer, USB flash drive,
USB hub, USB Sample Processor etc. 2 Ethernet connector (RJ-45)
For connecting to a network.
3 Temperature sensor connector (Temp.)
For connecting temperature sensors (Pt1000
or NTC). Two B sockets, 2 mm. 4 Electrode connector (Pol.)
For connecting polarizable electrodes, e.g.
double Pt electrodes. Socket F.
5 MSB connector (MSB 1 and MSB 2)
Metrohm Serial Bus. For connecting external
dosing devices, stirrers or a Remote Box.
Mini DIN, 8-pin. 6 Mains connection socket (Power)
For connecting the external power supply
unit.
7 Mains switch
Switch the instrument on/off. 8 Connection nipple for PVC tubing
For aspiration of the contents of the titration
cell.
9 Connection nipple for PVC tubing
For aspirating solvent. 10 Type plate
Contains the serial number.