Metrohm 915 KF Ti-Touch - Manual (Page 34)

4.6 Connecting sensors
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
20 ￭￭￭￭￭￭￭￭
915 KF Ti-Touch
Figure 6 Connecting a polarizable electrode
NOTE
The electrode cable is protected against accidental disconnection
of the cable by means of a pull-out protection. If you wish to
remove the plug, you will first need to pull back the outer plug
sleeve.
4.6.3 Connecting a temperature sensor
A temperature sensor of the Pt1000 or NTC type can be connected to the
Temp. connector.
Connect the temperature sensor as follows:
1 Plug the temperature sensor plugs into the Temp. sockets of the
Ti-Touch.