Metrohm 915 KF Ti-Touch - Manual (Page 26)

4.3 Connecting MSB devices
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
12 ￭￭￭￭￭￭￭￭
915 KF Ti-Touch
4.3 Connecting MSB devices
In order to connect MSB devices, e.g. dosing device or Remote-Box, the
Ti-Touch has two connectors at what is referred to as the Metrohm Serial
Bus (MSB). Various peripheral devices can be connected in sequence
(Daisy Chain) at a single MSB connector (8-pin Mini DIN socket) and be
controlled simultaneously by the Ti-Touch. In addition to the connection
cable, stirrers and the Remote Box are each equipped with their own MSB
socket for this purpose.
The following figure provides an overview of the devices that can be con-
nected to an MSB socket, along with a number of different cabling varia-
tions.
MSB
Stirrer / Ti Stand
Dosimat / Dosino
Dosimat
Remote Box
Dosino
Ti Stand / Stirrer
Figure 4 MSB connections
NOTE
When connecting MSB devices together, the following must be
observed:
￭ Only one device of the same type can be used at a single MSB con-
nector at one time.
￭ When making the connection, take care to ensure that the flat part
of the MSB plug marked with arrows is pointing in the direction of
the marking on the MSB connector (see Figure 5, page 13).