Carrier Access Network Device Axxius 800 - Manual (Page 107)

Axxius 800 - Release 2.2 5-7
CLI Commands
add
add (ds1) ais
Use the add (ds1) ais command to add DS1s to a list for the AIS Forwarding feature. The DS1
enabled for AIS forwarding will be checked against the DS1s defined in the list.
Note: If no list is defined, AIS will go to all the DS1s cross-connected to that DS1.
Syntax: add {ds1-addr} ais {all|{ds1-addr1}, [ds1-addr2],
[ds1-addr3], [ds1-addr4]}
Example: add 1:1 ais 2:1, 3:1, 4:1, 5:1
{ds1-addr}
Enter the DS1 that has AIS enabled.
The Controller DS1 addresses are different on the DS3 and DS1 Controller, however the
DS1 address on the services cards does not change with Controller type (DS3 or DS1).
all
Creates a AIS DS1 list all DS1s in the system to be configured to trigger sending AIS.
{ds1-addr1}, [ds1-addr2], [ds1-addr3], [ds1-addr4]
Creates a AIS DS1 list of up to 4 DS1s to be configured to trigger sending AIS.
DS1 Address on a DS3 Controller in the form {slot:port:channel}
slot A for the DS3 Controller card.
port Port number, list or all.
ds1 channel Channel number, list or all.
DS1 Address on a DS1 Controller or service cards (with DS1 or DS3 controller) in
the form {slot:port}
slot A for the DS1 Controller card, or 1-8 for service cards.
port Port number, list or all.