Carrier Access Network Device Axxius 800 - Manual (Page 276)

5-176 Axxius 800 - Release 2.2
CLI Commands
show
show (adpcm)
Use the show (adpcm) command to display the settings for the ADPCM card.
Syntax: show {adpcm-addr}
Example: > show 6:1
show 6:1
SLOT 6:
Settings for DS1 1:
Circuit ID: CAC DS1# 6:1
Up/Down: UP
Framing: ESF
Line Coding: B8ZS
Line Build Out: DSX-1 EQUALIZATION FOR 0-133 ft.
(CSU 0dB)
Loop Code Detection: ON
Loopback: OFF
FDL Type: None
ADPCM: Enabled
ADPCM Map: 2
Performance Threshold Settings 15 min. 1 day
unavailable seconds: 0 0
severely errored seconds: 0 0
errored seconds: 0 0
sev. errored frame seconds: 0 0
line errored seconds: 0 0
controlled slip seconds: 0 0
bursty errored seconds: 0 0
degraded minutes: 0 0
total linecode violations: 0 0
total pathcode violations: 0 0
{adpcm-addr}
The ADPCM address is in the form {slot|slot:port}. Where {slot} displays information for
all ports on the card, {slot:port} for only the defined port.
slot Slot number (1-8) where the ADPCM card is located
port Port number, range or all.