Carrier Access Network Device Axxius 800 - Manual (Page 339)

Axxius 800 - Release 2.2 5-239
CLI Commands
status
Example: status equipment 3
The example with display the status of the card in slot 4. In this example a TSR
card is in this slot.
> status equipment 3
SLOT 3
CardType: TSRx4
Status: Present
SW Revision: 1.30H
BootCode Version: 2.22
FPGA Revision: 1.01
CLEI: SIL1UW0EAA
[slot]
If a slot number is not entered, the status of the all slots will be displayed.
status (fxo)
Use the status (fxo) to display the current near-end line status of the specified FXO.
Syntax: status {fxo-addr}
Example: status 5:2
The example displays status of port 2 (FXO) on slot 5.
> status 5:2
FXO Rx AB Tx AB Signal=>T1 sig T1 TP
--- ----- ----- -------------- ----------------- --
5:2 01 10 GS=>GS Traffic N
See Display Descriptions on page 5-231 for definitions of column headings.
{fxo-addr}
slot A for the controller card, or 1-8 for service cards.
slot The slot number (1-8) that contains the FXO card
port Port number or range.