Carrier Access Network Device Axxius 800 - Manual (Page 348)

5-248 Axxius 800 - Release 2.2
CLI Commands
status
status (router) ip network table
Use the status (router) ip network table command to display the current table of learned
IP Networks for the specified interface on the Router card.
Syntax: status {rtr_card-addr} ip network table
["profile-name"]
Example: status 5 ip network table
> status 5 ip network table
ROUTER BLADE IP NETWORKS REPORT Slot-5
Total Entries-3 on 2 Ports
Display: <IP Networks > Learned From: <All Ports >
Network Subnet Mask Metric Next Gateway Port Name
1. Static 200.1.1.0 255.255.255.0 1 LosAngeles
2. Static 100.0.0.0 255.0.0.0 1 192.136.43.52 Local LAN
3. Direct 192.168.3.0 255.255.255.0 1 192.168.3.196 Local LAN
Example: status 5 ip network table "Axxius50"
> status 5 ip network table "Axxius50"
ROUTER BLADE IP NETWORKS REPORT Slot-5
Total Entries-2 on Local LAN
Display: <IP Networks > Learned From: <Local LAN >
Network Subnet Mask Metric Next Gateway Frame
1. Static 100.0.0.0 255.0.0.0 1 192.136.43.52 Eth II
2. Direct 192.168.3.0 255.255.255.0 1 192.168.3.196 Eth II
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
["profile-name"]
The profile name for the Router interface that is used to reach this destination. Name must
be enclosed in quotes, with a maximum length of 11 characters.