Carrier Access Network Device Axxius 800 - Manual (Page 383)

Axxius 800 - Release 2.2 7-11
DS3 Controller Card
Configuration
Configuration
Options on the DS3 Controller card are set by the following CLI commands.
CLI Commands
The following commands are used to configure the DS3 Controller card. For detailed
information on these commands, see Chapter 5, CLI Commands.
l connect
Creates two-way connections between channels
l disconnect
Removes a connection created by the connect command
l set clock
Sets the signal clock switching
l set clock (1 and 2)
Sets the primary and secondary transmit clock
l set date
Sets the date for the system
l set (ds3)
Sets up the DS3 interfaces (up, down, berthreshold, clock, dejitter,
equipment, facility ID, frame, framing, generator number, ID, line loopup,
location ID, loopdetect, payload, port number, protect, reversion, threshold,
unit ID)
l set ipds0
Sets up the DS0 management channel (assign, disable, down, IP address, up)
l show (ds3)
Displays current settings for a DS3
l show ipds0
Displays the settings for the DS0 management channel
l status (ds3)
Displays the status of the DS3 (receive, transmit, loopback)
l status ipds0
Display the status of the DS0 management channel