Show (router-wan), Show (router-wan) -212, Cli commands – Carrier Access Network Device Axxius 800 User Manual
Page 312
5-212
Axxius 800 - Release 2.2
CLI Commands
show
show (router-wan)
The show (router-wan) command displays the current configuration settings for the specified
WAN interface.
Syntax:
show {rtr_card-addr} {"wan-name"}
Example:
show 3 "RemoteUnit"
> show 3 "RemoteUnit"
SLOT 3:
Settings for TSR WAN LosAngeles:
State: Enabled
IP Settings:
Mode: Route
WAN Network Updates: Never
GRE Tunneling: Disabled
IPX Settings:
Mode: Blocked
Other Settings:
Mode: Blocked
NAT Gateway: Disabled
WAN Numbered IP: No
WAN PPP Authentication/Security Settings for RemoteUnit:
Authentication of Remote User:
User ID: Remote Profile Name: RemoteUnit
Security Server: Local
Compression: Disabled
Typical Data: Easy to Compress
PPP Statistics for Slot-3:
Up/Down Rx Rx Tx Tx
Remote Name State Time Packets Octets Packets Octets
RemoteUnit DOWN 38m30s 0 0 0 0
WAN Trunk Setting for RemoteUnit:
No Trunk Assigned