Carrier Access Network Device Axxius 800 - Manual (Page 407)

Axxius 800 - Release 2.2 10-7
OCU-DP Card
Card Configuration
Card Configuration
OCU-DP card options are set with the Command Line Interface (CLI). For additional
information on these commands, see Chapter 5, CLI Commands.
CLI Commands
Configuration Commands
l set lsbackup
Set up OCU-DP port baud rate
l set (ocudp) loopdetect
Set OCU-DP non-latching/latching loopback code detection
l set (ocudp) mvec
Set Majority Vote Error Correction (MVEC)
l set (ocudp) secondary
Set up the secondary channel service
l set (ocudp) up/down
Set the OCU-DP line In or Out-of-Service.
Test Commands
l set (ocudp) loopback
Set the manual loopback tests
l set (ocudp) selftest
Start the OCU-DP self test
OCU-DP Status Commands
l clear (ocudp) performance
Clear OCU-DP status counters
l show (ocudp)
Displays OCU-DP card configuration (baud, loopdetect, error correction,
switched and enhanced switched service and secondary channel
provisioning)
l status (ocudp)
Displays the status or performance statistics of the OCU-DP card (OOS,
LOF, LOS and BPV seconds)