Set cclabel, Set clock, Set cclabel -74 – Carrier Access Network Device Axxius 800 User Manual
Page 174: Set clock -74, E set clock
5-74
Axxius 800 - Release 2.2
CLI Commands
set
set cclabel
Use the set cclable command to set a user defined cross-connect label.
Syntax:
set cclabel {addr} {"label"}
Example:
set cclabel a:1:1 "Idle Ch"
The example will set a user connect label "Idle Ch" on the DS0 a:1:1.
{addr}
{label}
The user defined label can be up to 8 characters, and must be enclosed in quotes.
set clock
Use the set clock command to configure signal clock switching.
Syntax:
set clock {nonrevertive|revertive|switch}
Example:
set clock nonrevertive
The example set the signal clock to nonrevertive mode.
{nonrevertive|revertive|switch}
ds0-addr
In the form of {slot:port|slot:port:channel}.
fxsPS-addr
In the form of {slot:port}.
fxsPSM-addr
In the form of {slot:port}.
tsr_trunk-addr
In the form of {slot:port:channel}.
v35-addr
In the form of {slot:port}.
nonrevertive
Nonrevertive mode, meaning that the clock will not switch back to a
recently failed clock once that clock is restored
revertive
Revertive mode, the clock will automatically switch back and forth, if
possible, to a known good clock signal source
switch
Force a signal clock switch-over. Allows the user to manually switch
from the primary clock to the secondary clock, and vice versa. Clock
source must be healthy for a switch to take place. This command is
not valid in revertive mode.