Carrier Access Network Device Axxius 800 - Manual (Page 264)

5-164 Axxius 800 - Release 2.2
CLI Commands
set
set (router-wan) stp port cost
Use the set (router-wan) stp port cost command to configure Spanning Tree path cost
value for this bridge port.
Syntax: set {rtr_card-addr} {"wan-name"} stp port cost
{port-cost-value}
Example: set 3 stp port cost 650
The example sets the Spanning Tree port cost value at 650, on the Router card
in slot 3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{port-cost-value}
The value can range from 1 to 65535, with higher values representing slower data paths. A
value of 15625/# of DS0s is recommended.
set (router-wan) stp port priority
Use the set (router-wan) stp port priority command to configure Spanning Tree priority
value for this bridge port.
Syntax: set {rtr_card-addr} {"wan-name"} port priority
{port-priority-value}
Example: set 3 stp port priority 128
The example sets the Spanning Tree port priority to 128, on the Router in slot 3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{port-priority-value}
The value can range from 0 to 255 seconds, with a default of 128.