Carrier Access Network Device Axxius 800 - Manual (Page 125)

Axxius 800 - Release 2.2 5-25
CLI Commands
add
{src-ip-addr/bits}
The destination IP address and number of significant bits. The address "0.0.0.0/0" matches
any address.
src-ip-addr Enter the IP Address of the remote device or network that this rule
will affect. If you enter the address of a remote device, this rule will
affect only the session establishments of the remote device and the
destination address entered in the dest-ip-addr/bits command above.
The IP Address is in the form of xxx.xxx.xxx.xxx, where xxx is
between 0-255.
bits Use this field to identify the number of bits, from left to right that
will be used to match the IP Address field within the data packet.
Range is between 1-32.