Carrier Access Network Device Axxius 800 - Manual (Page 217)

Axxius 800 - Release 2.2 5-117
CLI Commands
set
set (router) port flowcontrol
Use the set (router) port flowcontrol command to set the flow control on a TSR port. This
command controls the transfer of messages or characters between two points in a data
network to prevent congestion, or loss of data when the receiving device’s buffer begins to
reach its capacity.
Syntax: set {tsr_card-addr} port {port-number} flowcontrol
{none|rtscts|xonxoff}
Example: set 5 port 2 flowcontrol none
The example will set the flowcontrol to none on the second port on the TSR card
in slot 5.
{tsr_card-addr}
The slot number (1-8) that contains the TSR card.
{port-number}
The port number (1-4) of the TSR card.
{none|rtscts|xonxoff}
none Set flow control to none
rtscts Set flow control to hardware
xonxoff Set flow control to xonxoff