Carrier Access Network Device Axxius 800 - Manual (Page 212)

5-112 Axxius 800 - Release 2.2
CLI Commands
set
set (router) login prompt
Use the set (router) login prompt command to enable/disable the login prompt on the
specified Router card.
Syntax: set {rtr_card-addr} login prompt {disable|enable}
Example: set 1 login prompt enable
The example will set the Router card to require a login with Telnets from the
Controller.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{controller|local|radius}
set (router) ntp
Use the set (router) ntp command to setup Network Time Protocol (NTP) parameters.
Note: not operational in this release.
set (router) ntp enable/disable
Use the set (router) ntp enable/disable command to enable/disable NTP processing.
Syntax: set {rtr_card-addr} ntp {disable|enable}
Example: set 1 ntp enable
The example will enable NTP processing on the Router card in slot 1.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{disable|enable}
disable Disable the login prompt
enable Enable the login prompt
disable Disable NTP processing
enable Enable NTP processing