Carrier Access Network Device Axxius 800 - Manual (Page 206)

5-106 Axxius 800 - Release 2.2
CLI Commands
set
set (router) dhcp server netbios nodetype
Use the set (router) dhcp server netbios nodetype command to set the NetBIOS node
type (see RFC 1001/1002) that the DHCP server provides to clients.
Syntax: set {rtr_card-addr} dhcp server netbios nodetype
{type-number}
Example: set 5 dhcp server netbios nodetype 1
The example will set the NetBIOS node type to B-node.
Note: DHCP server must first be enabled with the "startaddr" command. See set
(router) dhcp server startaddr on page 5-107.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{type-number}
The value is specified as a single octet that identifies the client type.
set (router) dhcp server netbios scope
Use the set (router) dhcp server netbios scope command to set the NetBIOS scope value
(see RFC 1001/1002) that the DHCP server provides to clients.
Syntax: set {rtr_card-addr} dhcp server netbios scope
{scope-name}
Example: set 5 dhcp server netbios scope "Accounting"
Note: DHCP server must first be enabled with the "startaddr" command. See set
(router) dhcp server startaddr on page 5-107.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{scope-name}
The Scope is a DHCP option that represents a grouping of computers on a subnet using the
same NetBIOS name. Enter up to 41 alphanumeric characters for the scope-name, enclosed
in quotes.
1 B-node 4 M-node
2 P-node 8 H-node