Carrier Access Network Device Axxius 800 - Manual (Page 371)

Axxius 800 - Release 2.2 6-9
DS1 Controller Card
Configuration
Configuration
Options on the Quad DS1 Controller card are set by the Command Line Interface
(CLI). Note: the faceplate state DS1/E1 Controller, the E1 feature is not supported on
this release.
CLI Commands
The following commands are used to configure the Quad DS1 Controller card. For
detailed information on these commands, see Chapter 5, CLI Commands.
l connect
Creates two-way connections between channels
l disconnect
Removes a connection created by the connect command
l set clock (1 and 2)
Sets the primary and secondary transmit clock
l set date
Sets the date for the system
l set (ds1)
Sets up the DS1 interfaces (up, down, BP violation, FDL, framing, ID string,
line build out, line loopup, linecode, loopdetect, payload, threshold)
l set ipds0
Sets up the DS0 management channel (assign, disable, down, IP address, up)
l show (ds1)
Displays current settings for DS1 (circuit ID, up, down, framing, line
coding, clock source, line build out, loop code detection, loop back, FDL
type)
l show ipds0
Displays the settings for the DS0 management channel
l status (ds1)
Displays the status of the DS1 (receive, transmit, loopback)
l status ipds0
Display the status of the DS0 management channel