Carrier Access Network Device Axxius 800 - Manual (Page 273)

Axxius 800 - Release 2.2 5-173
CLI Commands
set
[nnn] chart
pattern Syntax: set{v54-addr} v54 equipment pattern {n}
Set V.54 test pattern n is from the following:
0 = QRSS pattern (default)
1 = 2047 pattern
2 = 2
15
-1 pattern
3 = 2
20
-1 pattern (QRSS with no bit stuffing)
prepcnt Syntax: set {v54-addr} v54 equipment prepcnt {nnn}
Set V.54 Rx prep-pattern count {nnn}
nnn = the number of times that the preparatory pattern must be
received to be recognized.
network Set the V.54 Network loop address.
address Syntax: set {v54-addr} v54 network address {nnn}
Set the address of the port to {nnn}.
{nnn} must be one of the following:
1, 3, 5, 7, 9, 11, 13, 15,17, 19, 21, 23, 25, 27, 29, 31, 37, 39, 43, 45,
47, 51, 53, 55, 59, 61, 63, 85, 87, 91, 95, 111, 119, 127, 255 (255
disables). See chart below.
disable Syntax: set {v54-addr} v54 network disable
Disable V.54 loop test
enable Syntax: set {v54-addr} v54 network enable
Enable V.54 loop test
prepcnt Syntax: set {v54-addr} v54 network prepcnt {nnn}
Sets the preparatory pattern response count.
nnn = the number of times that the preparatory pattern must be
received to be recognized.
0x01 - 1 0x0F - 15 0x1D - 29 0x33 - 51 0x57 - 87
0x03 - 3 0x11 - 17 0x1F - 31 0x35 - 53 0x5B - 91
0x05 - 5 0x13 - 19 0x25 - 37 0x37 - 55 0x5F - 95
0x07 - 7 0x15 - 21 0x27 - 39 0x3B - 59 0x6F - 111
0x09 - 9 0x17 - 23 0x2B - 43 0x3D - 61 0x77 - 119
0x0B - 11 0x19 - 25 0x2D - 45 0x3F - 63 0xFF - 255*
0x0D - 14 0x1B - 27 0x2F - 47 0x55 - 85