Carrier Access Network Device Axxius 800 - Manual (Page 135)

Axxius 800 - Release 2.2 5-35
CLI Commands
clear
clear (ds1)
Use the clear (ds1) command to clear specified DS1 performance data.
Syntax: clear {ds1-addr} performance {setting}
Example: clear a:1 performance all
Clears all performance data on DS1 1 (port 1) on the DS1 Controller card.
{ds1-addr}
The Controller DS1 addresses are different on the DS3 and DS1 Controller, however the
DS1 address on the services cards does not change with Controller type (DS3 or DS1).
{setting}
DS1 Address on a DS3 Controller in the form {slot:port:channel}
slot A for the DS3 Controller card.
port Port number, range or all.
ds1 channel Channel number, range or all.
DS1 Address on a DS1 Controller (DS1 mode) or service cards (with DS1 or DS3
controller) in the form {slot:port}
slot A for the DS1 Controller card (DS1 mode), or 1-8 for service cards.
port Port number, range or all.
all Clear all performance data
bes Clear bes (bursty errored seconds) performance data.
css Clear css (controlled slip seconds) performance data.
dm Clear dm (degraded minutes) performance data.
es Clear es (errored seconds) performance data.
lcv Clear lcv (line code violations) performance data.
les Clear les (line errored seconds) performance data.
pcv Clear pcv (path code violations) performance data.
sefs Clear sefs (severely errored frame seconds) performance data.
ses Clear ses (severely errored seconds) performance data.
uas Clear uas (unavailable seconds) performance data.