Carrier Access Network Device Axxius 800 - Manual (Page 226)

5-126 Axxius 800 - Release 2.2
CLI Commands
set
set (router) ppp auth byremote user
Syntax: set {rtr_card-addr} ppp auth byremote user
{profilename|"protocol-name"}
Example: set 5 ppp auth byremote user profilename
The example will set the PPP authentication user name for the Router in slot 5
to equal the profile name.
Note: A set (router) ppp auth byremote protocol command must be
completed before this command can be implemented.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{profilename|"protocol-name"}
set (router) ppp auth ofremote protocol
Syntax: set {rtr_card-addr} ppp auth ofremote protocol
{chap|none|pap}
Example: set 5 ppp auth ofremote protocol none
The example will set the Router in slot 5 to not allow PPP authentication of this
Axxius by the Router.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{chap|none|pap}
profilename Use the profile name as the CHAP or PAP user name.
"protocol-name" The CHAP or PAP user name. A maximum of 16 characters,
enclosed in quotes.
chap Set to the CHAP protocol.
none The remote PPP device cannot authenticate this Axxius (default).
pap Set to the PAP protocol.