Carrier Access Network Device Axxius 800 - Manual (Page 253)

Axxius 800 - Release 2.2 5-153
CLI Commands
set
set (router-wan) gre
Use the set (router-wan) gre command to configure Generic Routing Encapsulation tunneling
for a specified WAN interface.
set (router-wan) gre address
Use the set (router-wan) gre address command to configure the IP addresses for GRE
tunneling for a specified WAN interface.
Syntax: set {rtr_card-addr} {"wan-name"} gre address
{local_ip-addr} [remote-ip-addr] ["tunnel-name"]
Example: set 3 "LosAngeles" gre address 10.0.0.0 20.0.0.0
"LATunnel"
The example will set the WAN interface named "LosAngeles" to the IP
addresses to be 10.0.0.0 and 20.0.0.0.
Note: A set 3 "LosAngeles" gre ip all command is required before this
command.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{local-ip-addr}
The IP Address of the local end of the tunnel, in the form of xxx.xxx.xxx.xxx, where xxx
is between 0-255.
[remote-ip-addr]
The IP Address of the far end of the tunnel, required if GRE tunneling is set to All,
prohibited if GRE tunneling is set to By Network. In the form of xxx.xxx.xxx.xxx, where
xxx is between 0-255.
["tunnel-name"]
A symbolic name to give to this tunnel, required if GRE tunneling is set to All, prohibited
if GRE tunneling is set to By Network. Up to 12 characters, enclosed in quotes.