Set (router-wan) rip, Set (router-wan) rip -162 – Carrier Access Network Device Axxius 800 User Manual
Page 262
5-162
Axxius 800 - Release 2.2
CLI Commands
set
set (router-wan) rip
Use the set (router-wan) rip commands to set the type of RIP updates on the WAN interface.
set (router-wan) rip ip updates
Use the set (router-wan) rip ip updates command to set the type of RIP updates on the
specified WAN interface.
Syntax:
set {rtr_card-addr} {"wan-name"} rip ip updates
{never|periodic|triggered}
Example:
set 1 "LosAngeles" rip ip updates never
The example will set the WAN interface named "LosAngeles" on the Router
card in slot 1 to not sent RIP updates.
{rtr_card-addr} -
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{setting}
set (router-wan) rip ipx updates
Use the set (router-wan) rip ipx updates command to set the type of IPX RIP updates on
the specified WAN interface.
Syntax:
set {rtr_card-addr} {"wan-name"} rip ipx updates
{never|periodic|triggered}
Example:
set 1 "LosAngeles" rip ipx updates never
Sets the WAN interface "LosAngeles" to not sent RIP updates.
{rtr_card-addr} -
The slot number (1-8) that contains the TSR card.
{"wan-name"} -
The WAN interface to modify. The name must be enclosed in quotes.
{setting}
never
Set the WAN to not send RIP updates.
periodic
Set the WAN to send periodic RIP updates.
triggered
Set the WAN to send triggered RIP updates.
never
Set the WAN to not send RIP updates.
periodic
Set the WAN to send periodic RIP updates.
triggered
Set the WAN to send triggered RIP updates.