Carrier Access Network Device Axxius 800 - Manual (Page 256)

5-156 Axxius 800 - Release 2.2
CLI Commands
set
set (router-wan) ipx
Use the set (router-wan) ipx command to set the IPX traffic handling on the specified WAN
interface.
Syntax: set {rtr_card-addr} {"wan-name"} ipx {setting}
Example: set 1 "LosAngeles" ipx bridge
The example will set the WAN interface named "LosAngeles" in slot 1, to
bridge IPX.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{setting}
block Set the WAN to block IPX.
bridge Set the WAN to bridge IPX with optimized local advertising IPX
servers and networks.
optimize Set the WAN to bridge IPX with optimized local advertising of
IPX servers and networks.
Setting to optimize enables the Axxius to use Carrier Access’
network optimization feature, which ensures that only necessary
data is transmitted over the WAN connection. The Axxius will
initiate IPX learning mode. Learning mode is effective for
optimizing bandwidth usage for IPX RIP, SAP, serialization and
watchdog (IPX and SPX) packets. If you choose this option, the
Axxius will initiate learning mode in order to gain knowledge of
local and remote networks and services. Once it knows of remote
networks and services, it can advertise the information on the local
LAN on behalf of the remote networks and servers.