Carrier Access Network Device Axxius 800 - Manual (Page 216)

5-116 Axxius 800 - Release 2.2
CLI Commands
set
set (router) port databits
Use the set (router) port databits command to set the data bits on a TSR port.
Syntax: set {tsr_card-addr} port {port-number} databits
{5|6|7|8}
Example: set 5 port 2 databits 6
The example will set the data bits to 6 on the port 2 on the TSR card in slot 5.
{tsr_card-addr}
The slot number (1-8) that contains the TSR card.
{port-number}
The port number (1-4) of the TSR card.
{5|6|7|8}
Allowable data bits. Note: If 1.5 Stop Bits is selected, the Data Bits setting MUST be 5
Data Bits, if 2 Stop Bits is selected, 5 Data Bits MUST NOT be selected. See set (router)
port stopbits on page 5-122.
set (router) port dsr low reset
Use the set (router) port dsr low reset command to cause a RE-232 session to terminate
when DSR (Data Set Ready) goes low. This setting can be issued when the card is
physically strapped for Ethernet, but has not effect. This setting also only goes into effect
when the DSR signal is high. This setting can be done for any application type but is only
active for termserv and rawtcp modes.
Syntax: set {tsr_card-addr} port {port-number} dsr low reset
{disable|enable}
Example: set 5 port 2 dsr low reset enable
{tsr_card-addr}
The slot number (1-8) that contains the TSR card.
{port-number}
The port number (1-4) of the TSR card.
{disable|enable}
disable Disable will not use the reset feature. Default
enable Enable causes the session to teardown when DSR goes low.