Carrier Access Network Device Axxius 800 - Manual (Page 64)

3-8 Axxius 800 - Release 2.2
Electrical Installation and Cabling
Chassis Connections
5. Ensure that no bare wire shows after the wires are installed.
6. Plug connector in the INPUT (power) connector, as seen in the graphic and
secure with set screws.
7. Apply power to connector.
8. Verify with voltmeter that voltage is correct and polarity is correct.
9. Plug connector(s) into the Axxius 800.
10. A green light should appear on the DC Input LED on the front of the Power
Supply.
Provided Connector (male)
+
Set Screw
Tighten screws
to clamp wires
-