Carrier Access Network Device Axxius 800 - Manual (Page 82)

4-10 Axxius 800 - Release 2.2
Configuration
Basic System Setup
Set Up a Single Channel POTS card
Use the following commands to set up a POTS card.
Change the IP Address of the DS0 Management Channel
Use the following commands to change the IP over DS0 Management Channel for the
Axxius 800.
Command Description
set {fxsPS-addr|fxsPSM-addr}
{ls|lsrb}
Set the signaling option for the port. See the
set (fxsPS or fxsPSM) command for details.
set {fxsPS-addr|fxsPSM-addr}
rxgain {n}
Set the receive gain/loss in dB. See the set
(fxsPS or fxsPSM) command for details.
set {fxsPS-addr|fxsPSM-addr}
txgain {n}
Set the transmit gain/loss in dB. See the set
(fxsPS or fxsPSM) command for details.
Command Description
set ipds0 down Set the DS0 management channel down
set ipds0 ip address {ip-addr} Set the DS0 management channel IP address.
set ipds0 up Set the DS0 management channel up.