Carrier Access Network Device Axxius 800 - Manual (Page 510)

B-8 Axxius 800 - Release 2.2
SNMP Interface
SNMP Trap Reports
SNMP Trap Reports
The Axxius 800 can send the following SNMP trap reports.
Standard Traps
Enterprise Traps
Trap Description Test Method
authentication
Failure Occurs when a bad community string is used. Attempt a Get or Set
using an invalid
community string.
linkDown Sent when a DS1 changes from an up (in-service) state to
a down (out-of-service) state. It is not sent when a DS1 is
set “down” by a manual command.
Also sent when a DS1 is set up manually, if it is in an out-
of-service state. Disconnect an in-
service DS1.
linkUp Sent when a DS1 changes from a down (out-of-service)
state to an up (in-service) state. It is not sent when a DS1
is set “up” by a manual command. Connect a DS1 and
put it into service.
coldStart Sent whenever the SNMP agent is restarted as a result of a
software reset or unit powerup. Cycle the power off
and on.
Trap Description Test Method
caGenEventLo
gTrap This trap is generated when an event has been logged into the
device's Event Log. This trap contains 5 mandatory variable
bindings and may contain up to 3 optional variable bindings.
The mandatory variable bindings are caGenEventLogIndex,
caGenEventSeverity, caGenEventCategory,
caGenEventCode, and caGenEventDate. The optional
variable bindings are caGenEventInfoParam1,
caGenEventInfoParam2 and caGenEventAdditionalText. The
optional variable bindings (if present) will always appear at
the end of the variable binding list.