Carrier Access Network Device Axxius 800 - Manual (Page 436)

13-6 Axxius 800 - Release 2.2
Quad DS1 ADPCM Card
Card Configuration
Card Configuration
All options on the this Service card are set using the Command Line Interface (CLI).
CLI Commands
The following commands are used to configure the Quad DS1 ADPCM card. For
detailed information on these commands, see Chapter 5, CLI Commands.
l connect
Creates two-way connections between channels.
l disconnect
Removes a connection created by the connect command.
l set (ds1 card) adpcm map
Sets the voice compression map on the ADPCM card (none, map 1, map 2
or map 3).
l set (ds1)
Sets up the DS1 interfaces (clock, up, down, fdl, framing, id string, lbo, line,
linecode, loopdetect).
l set lsbackup
Defines the backup protection slot.
l set lsprotect enable/disable
Enables or disables the Low Speed Protection options on the system.
l set lsprotect manual
Sets the manual mode control for protected ports.
l set lsprotect nonrevertive
Defines the port non-revertive status and priority level.
l set lsprotect remove
Removes port from protected mode.
l set lsprotect revertive
Defines the port revertive status and priority level.