Carrier Access Network Device Axxius 800 - Manual (Page 237)

Axxius 800 - Release 2.2 5-137
CLI Commands
set
set (router) syslog
Use the set (router) syslog commands to configure the Router to send alarm and event
messages to a Syslog server.
set (router) syslog enable/disable
Use the set (router) syslog enable/disable command to enable and disable sending alarm
and event messages to an external Syslog server from the Router.
Syntax: set {rtr-addr} syslog {disable|enable}
Example: set 3 syslog enable
The example will enable alarms and event messages to the external Syslog
server, on the Router card in slot 3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{disable|enable}
set (router) syslog facility
Use the set (router) syslog facility command to set the Syslog facility value that the Router
card will report to a syslog server in each message.
Syntax: set {rtr_card-addr} syslog facility {value}
Example: set 3 syslog facility 16
The example will set the Syslog facility value to 16, on the Router in slot 3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{value}
The range of valid facility values is from 0 to 23, with a default of 16 (local use 0).
disable Disable Syslog protocol
enable Enable Syslog protocol