Carrier Access Network Device Axxius 800 - Manual (Page 209)

Axxius 800 - Release 2.2 5-109
CLI Commands
set
set (router) dns resolver
Use the set (router) dns resolver command to enable/disable use of DNS resolver to
convert domain names to IP addresses. The DNS server address must be set before the DNS
resolver can be enabled.
Syntax: set {rtr_card-addr} dns resolver {disable|enable}
Example: set 3 dns resolver disable
The example will disable the DNS resolver for the Router in slot 3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{disable|enable}
set (router) dns server
Use the set (router) dns server command to configure the IP address of DNS servers.
Syntax: set {rtr_card-addr} dns server {1|2} {ip-addr}
Example: set 3 dns server 1 10.10.10.0
The example will set the IP address of the DNS server number 1 to 10.10.10.0
for the Router in slot 3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{1|2}
{ip-addr}
The IP address, in the form of xxx.xxx.xxx.xxx, where xxx is between 0-255.
disable Disable DNS resolver
enable Enable DNS resolver
1 Setup IP address of DNS server 1
2 Setup IP address of DNS server 2