Carrier Access Network Device Axxius 800 - Manual (Page 269)

Axxius 800 - Release 2.2 5-169
CLI Commands
set
set user
Use the set user command to modify attributes for a specific user that have been created with
the add user command.
set user level
Use the set user level command to set the user access level.
Syntax: set user {"user-name"} level {1|2|3}
Example: set user "paul" level 2
{"user-name"}
The user-name is a user ID to add to the system. Text is a single word, with no blank spaces
and must be enclosed in quotes.
{1| 2| 3}
Sets the level of access.
set user password
Use the set user password to set the password for a defined user.
Syntax: set user {"user-name"} password
Example: set user "john" password [Enter]
New Password: ****
New Password again: ****
{"user-name"}
The user-name is an existing user ID in the system. Text is a single word, with no blank
spaces and must be enclosed in quotes.
Level 1 Manager has full access to ALL commands. Typically, there is only one
designated user at this level
Level 2 Operator has access to all commands except for the add user and set user
commands
Level 3 Monitor (read only) has access to commands that display reports and status