Carrier Access Network Device Axxius 800 - Manual (Page 449)

Axxius 800 - Release 2.2 14-7
Quad T1 & Quad DS1/E1 Card
Card Configuration
Card Configuration
All options on the this card are set using the Command Line Interface (CLI).
CLI Commands
The following commands are used to configure the Quad T1 card. For detailed
information on these commands, see Chapter 5, CLI Commands.
l connect
Creates two-way connections between channels.
l disconnect
Removes a connection created by the connect command.
l set (ds1)
Sets up the DS1 interfaces
l set lsbackup
Defines the backup protection slot.
l set lsprotect enable/disable
Enables or disables the Low Speed Protection options on the system.
l set lsprotect manual
Sets the manual mode control for protected ports.
l set lsprotect nonrevertive
Defines the port non-revertive status and priority level.
l set lsprotect remove
Removes port from protected mode.
l set lsprotect revertive
Defines the port revertive status and priority level.
l show lsprotect
Displays the low speed protection settings.
l show (ds1)
Displays current settings for DS1
l status (ds1)
Displays the status of the DS1 (receive, transmit, loopback)
l status lsprotect
Displays the current status of the low speed protection cards.