Carrier Access Network Device Axxius 800 - Manual (Page 173)

Axxius 800 - Release 2.2 5-73
CLI Commands
set
set (bri) mode
Use the set (bri) mode command to set the mode for the ISDN BRI Service.
Syntax: set {bri_card-addr} mode {setting}
Example: set 4 mode nt3ds0
To set the BRI card in slot 4 to use 3 DS0 LUNT
{bri_card-addr}
The slot number (1-8) of the Adit chassis that contains the BRI card.
{setting}
set (bri) pmsync
Use the set (bri) pmsync command to set the source for performance monitoring
synchronization.
Syntax: set {bri_card-addr} pmsync {setting}
Example: set 4 pmsync axxius
To set the BRI card in slot 4 source for performance monitoring synchronization
to Axxius.
{bri_card-addr}
The slot number (1-8) that contains the BRI card.
{setting}
Set the operating mode to one of the following:
lt3ds0 Set the BRI card mode to 3 DS0 LULT, used primarily for a subscriber line.
nt3ds0 Set the BRI card mode to 3 DS0 LUNT, used primarily for a central office
connection.
axxius Set source to the Axxius
switch Set source to the switch