Carrier Access Network Device Axxius 800 - Manual (Page 126)

5-26 Axxius 800 - Release 2.2
CLI Commands
add
add (router-wan) gre network
Use the add (router-wan) gre network command to add a "by network" Generic Route
Encapsulation (GRE) tunnel to a WAN.
Syntax: add {rtr_card-addr} {"wan-name"} gre network
{ip-addr mask|ip-addr/bits} {metric}
{remote-ip-addr} {"tunnel-name"}
Example: add 3 "LosAngeles" gre network 10.0.0.0/8 3 2.2.2.2
"LATunnel"
The example will set the WAN interface named "LosAngeles" in slot 3 to pass
all packets destined for a host on subnet 10.0.0.0 through a GRE tunnel to
2.2.2.2.
Note: A set 3 "LosAngeles" gre ip by network command is required before
this command.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{ip-addr mask|ip-addr/bits}
{metric}
Enter a numeric value indicating the distance from your local network to the destination
network. Valid entries range from 1 to 15.
{remote-ip-addr}
The IP address of the far end of this tunnel, in the form of xxx.xxx.xxx.xxx, where xxx is
between 0-255.
{"tunnel-name"}
A symbolic name for this tunnel. Maximum of 12 characters and must be enclosed in
quotes.
ip-addr
mask The IP address and the subnet mask of the IP network to tunnel, each in the
form of xxx.xxx.xxx.xxx, where xxx is between 0-255.
ip-addr The IP Address of the IP network to tunnel, in the form of xxx.xxx.xxx.xxx,
where xxx is between 0-255.
bits The subnet mask, specified as the number of ones bits in the mask value.
Range is between 1-32.