Carrier Access Network Device Axxius 800 - Manual (Page 341)

Axxius 800 - Release 2.2 5-241
CLI Commands
status
status lsprotect
Use the status lsprotect command to display the current status of the low speed protection
cards.
Syntax: status lsprotect
Example: status lsprotect
> status lsprotect
Low Speed Protection Status:
Low Speed Protection Global Service Enable: ENABLED
Low Speed Protection Operational Status: ENABLED
Relay Card Status, Slot 9: INSTALLED
Backup Slot: 7
Backup Slot Type: Quad T1
Backup Slot Port Status:
PORT: LOS: LCV: XMIT: PRES:
1 NO NO NORM PRES
2 NO NO NORM PRES
3 NO NO NORM PRES
4 NO NO NORM PRES
Protected Port Status:
SLOT: PORT: TYPE: BACKUP: ENABLED: SWITCHMODE: LOCKOUT: LOS: LCV: XMIT:
PRES:
3 1 QT1 NO NO MANUAL N/A YES NO NORM PRES
3 2 QT1 NO NO MANUAL N/A YES NO NORM PRES
3 3 QT1 NO NO MANUAL N/A YES NO NORM PRES
3 4 QT1 NO NO MANUAL N/A YES NO NORM PRES
5 1 QT1 NO NO MANUAL N/A YES NO NORM PRES
6 1 QT1 NO NO MANUAL CNT= 2 YES NO NORM PRES
6 2 QT1 NO NO MANUAL CNT= 2 YES NO NORM PRES
6 3 QT1 NO NO MANUAL CNT= 2 YES NO NORM PRES
6 4 QT1 NO NO MANUAL CNT= 2 YES NO NORM PRES
Number of Protected Ports: 9