Carrier Access Network Device Axxius 800 - Manual (Page 333)

Axxius 800 - Release 2.2 5-233
CLI Commands
status
status (ds1) performance
Use the status (ds1) performance command to display the performance statistics for the
current (15 min) and previous (15 min, hour and day) information of a DS1.
Syntax: status {ds1-addr} performance
Example: status a:1 performance
SLOT A:
Performance Statistics for DS1 1:
current previous
15 min. 15 min. 1 hour 1 day
unavailable seconds: 89 900 2700 2700
severely errored seconds: 0 0 0 0
errored seconds: 0 0 0 0
sev. errored frame seconds: 0 0 0 0
line errored seconds: 0 0 0 0
controlled slip seconds: 0 0 0 0
bursty errored seconds: 0 0 0 0
degraded minutes: 0 0 0 0
total linecode violations: 0 0 0 0
total pathcode violations: 0 0 0 0
elapsed time in current 15 min. interval: 1:29
valid 15 min. intervals in hour: 3
valid 15 min. intervals in Day: 3
* - indicates threshold has been crossed.
{ds1-addr}
The Controller DS1 addresses are different on the DS3 and DS1 Controller, however the
DS1 address on the services cards does not change with Controller type (DS3 or DS1).
DS1 Address on a DS3 Controller in the form {slot:port:channel}
slot A for the DS3 Controller card.
port Port number, range or all.
channel Channel number, range or all.
DS1 Address on a DS1 Controller or service cards (with DS1 or DS3 controller) in
the form {slot:port}
slot A for the DS1 Controller card (DS1 mode), or 1-8 for service cards.
port Port number, range or all.