Carrier Access Network Device Axxius 800 - Manual (Page 164)

5-64 Axxius 800 - Release 2.2
CLI Commands
print
print
Use the print command to display the help information or print the configuration file.
Syntax: print {config|help}
print config
Print the configuration file for the Axxius 800. The operator may then save this to a text file,
which can be sent to another Axxius to automatically configure the system with the original
Axxius 800 configuration.
Syntax: print config [rtr_card-addr]
[rtr_card-addr] - The slot number (1-8) that contains the Router card.
Example: print config 5
This example would produce a configuration file of the Router in slot 5.
Axxius> print config 5
set verification off
-set 5 password view {password} is manual
-set 5 password config {password} is manual
-set 5 password admin {password} is manual
-set 5 enhanced security enable is manual
-set 5 password security {password} is manual
delete 5 remote "RemoteUnit"
set 5 stp enable
rename 5 "LocalUnit" "LocalAxxius"
set 5:1 ip address 192.168.3.195 255.255.255.0
add 5:1 secondary ip address 192.168.3.194 255.255.255.0
set 5:1 up
set 5:1 collision threshold high 500
add 5 remote "RemoteUnit"
reset 5
Example: print config
This example would produce a configuration file of the Controller.
1. While in a Telnet session to an Adit 600 select Terminal/Start Logging.
2. Name the file.
3. Type the CLI command print config.
4. Select Terminal/Stop Logging.
See Load Controller Configuration on page 18-10 for instructions to reload configuration to
Controller card.