Carrier Access Network Device Axxius 800 - Manual (Page 232)

5-132 Axxius 800 - Release 2.2
CLI Commands
set
set (router) snmp
Use the set (router) snmp command to set the SNMP contact, location and name on the
specified Router card.
set (router) snmp contact
Use the set (router) snmp contact command to set the value of sysContact on the specified
Router card.
Syntax: set {rtr_card-addr} snmp contact
{"contact-name"}
Example: set 1 snmp contact "John Doe"
The example will set the value of sysContact on the Router card in slot 1 to "John
Doe".
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"contact-name"}
The value of sysContact, with a maximum of 64 ASCII characters. Name must be enclosed
in quotes.
set (router) snmp location
Use the set (router) snmp location command to set the value of sysLocation on the
specified Router card.
Syntax: set {rtr_card-addr} snmp location
{"location-name"}
Example: set 1 snmp location "Newark"
The example will set the value of sysLocation on the Router card in slot 1 to
"Newark".
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"location-name"}
The value of sysLocation, with a maximum of 64 ASCII characters. Name must be
enclosed in quotes.