IAI America XSEL-KE - Manual (Page 63)

48
Part 1 Installation
As shown at left, use small screwdrivers to
remove the battery from the holder and then
install a new battery in the holder.
To remove the battery, slightly lift the top side
(open side) first and then push out the bottom
side (closed side).
[8] When the replacement of system-memory backup battery is complete, confirm that the battery is
installed securely. (Pay attention to the polarities of the battery.)
[9] Install the main CPU board, segment board and front panel in the reverse steps.
Before inserting the main CPU board and segment board, adjust the connector positions, insert
each board roughly, and then push it all the way in.
[10] Connect the controller and the actuator using the cables. Connect the power cable and turn on
the controller power.
>@ 5HYHUW³2WKHUSDUDPHWHU1R%DFNXSEDWWHU\LQVWDOODWLRQIXQFWLRQW\SH´WRWKHYDOXHUHFRUGHG
LQVWHSWUDQVIHUWKHVHWWLQJWRWKHFRQWUROOHUDQGWKHQSHUIRUPDIODVK520ZULWH
&RQILUPWKDWWKHIODVK520ZUiting process has completed.
>@ 3HUIRUPDVRIWZDUHUHVHWDQGUHVWDUWWKHFRQWUROOHU
[13] When the controller has been restarted, FRQILUPWKDWWKH65$0GDWDKDYHEHHQUHVWRUHG