IAI America XSEL-KE - Manual (Page 234)

219
Part 4 Commands
z PEXT (Set palletizing composition)
Command, declaration
Extension condition
(LD, A, O, AB, OB)
Input condition
(I/O, flag)
Command,
declaration
Operand 1 Operand 2
Output
(Output, flag)
Optional Optional PEXT
(Position
number)
Prohibited CP
Set palletizing composition.
The position number specified in operand 1 will be set for use in composition.
When a palletizing movement command is executed, the data of any valid axes other than the PX, PY
(and PZ)-axes in the specified point data will comprise the end-point coordinates of the composite axis.
If operand 1 is not specified, the position number for composition setting that was already declared will
become invalid.
If this command is executed before a BGPA is declared (= while palletizing setting is not enabled), an
error will generate.
If the output field is specified, the output will turn ON after this command is executed.
z OFPZ (Set palletizing Z-axis offset)
Command, declaration
Extension condition
(LD, A, O, AB, OB)
Input condition
(I/O, flag)
Command,
declaration
Operand 1 Operand 2
Output
(Output, flag)
Optional Optional OFPZ
Offset
value
Prohibited CP
Set the offset in the palletizing Z-axis direction.
The value specified in operand 1 will be set as the offset in the palletizing Z-axis direction.
The offset amount is set in mm and the effective resolution is 0.001 mm.
A negative value can also be specified as the offset, as long as the operation range will not be exceeded.
This offset is valid only at the end point of PACH (palletizing-point arch motion) operation.
If this command is executed before a BGPA is declared (= while palletizing setting is not enabled), an
error will generate.
If the output field is specified, the output will turn ON after this command is executed.