Festo Электромотор MTR-DCI - Manual (Page 116)

6. Operating, maintenance and diagnosis
6-8
Festo P.BE-MTR-DCI-IO-EN en 1209d
I/F
1)
Status
2)
Ready for operation
– Positioning procedure is completed
(Motion Complete)
– Controller and power end stage enabled. green
Not ready to operate and enable missing
– Nominal position not reached; positioning procedure
stopped
– Controller and power end stage not enabled red
Ready to operate, is not enabled
– Positioning procedure is completed
(Motion Complete)
– Controller and power end stage not enabled. green/red
Positioning mode
– Nominal position not reached
(positioning procedure runs)
– Controller and power end stage enabled
– or fault off
1) Two -colour LED
2) If there is no fault, i.e. LED ERROR = out
Tab. 6/4: LED “I/F” (interface/field bus)